연락처

텍트로닉스 담당자와 실시간 상담 6:00am-4:30pm PST에 이용 가능

전화

전화 문의

9:00am-6:00PM KST에 이용 가능

다운로드

매뉴얼, 데이터 시트, 소프트웨어 등을 다운로드할 수 있습니다.

다운로드 유형
모델 또는 키워드

피드백

What is the difference between “Trigger out” and “Sync out”?

질문:

What is the difference between “Trigger out” and “Sync out”?

답변:

Trigger and Sync Out are almost the same. They are only different in the burst mode, in inifinte-cycle mode.

Figure 1

Figure 1: Trigger out mode

Scope CH1 ->AFGCH1
Scope CH2 ->AFGTrigger out
Scope CH3 ->AFGTrigger in(with T connector)

In this case a Trigger out signal will happen every cycle. For frequencies higher than 5 MHz Trigger out will not happen every cycle but will be in sync with the output waveform.

Figure 2

Figure 2: Sync out mode

Scope CH1 ->AFGCH1
Scope CH2 ->AFGSync out
Scope CH3 ->AFGTrigger in(with T connector)

The Sync out is only one pulse. The Sync mode is used for creating a Master-Slave setup with two AFG products.


FAQ ID 56091

모든 FAQ 보기 »