질문:
When running SPC (signal path compensation) on my oscilloscope, I get the message that SPC failed. What does failing SPC indicate?
답변:
When an oscilloscope says SPC failed, 99.9 percent of the time it is a hardware failure that will need repair. A few things you can do before sending in for repair:
Make sure all inputs (probes and cables) are removed from all the channel inputs.
Make sure the oscilloscope has been warmed up (typically 20 minutes)
Run the oscilloscopes “Default Setup”
If not running the latest oscilloscope firmware, download and install the latest version from Tek.com.
If the oscilloscope still presents a SPC failure, the unit will need to come in for a repair
이 FAQ는 다음에 적용 됩니다:
제품 시리즈: DPO70000SX ATI 고성능 오실로스코프 DPO7000 MSO/DPO70000DX 혼합 신호/디지털 포스퍼 오실로스코프 MSO3000/DPO3000 MSO4000/DPO4000 MSO/DPO5000B 혼합 신호 오실로스코프
제품:
FAQ ID 59621
모든 FAQ 보기 »